王磊,霍文浩,唐国庆,但光局,孙冬婷,李扬,文俊

• 1:重庆江增船舶重工有限公司
• 2:船用涡轮增压器研发重庆市工业和信息化重点实验室
• 3:船舶与海洋工程特种装备和动力系统国家工程研究中心

摘要(Abstract)：

针对某型超临界二氧化碳（S-CO_2）轴流透平，结合不同工况试验测试结果进行了带粗糙度的仿真与测试的对比分析，重点讨论了壁面粗糙度对机组性能的影响。研究结果表明：采用的壁面粗糙度数值计算方法能够较为准确地评估透平不同负荷工况性能；与测试结果相比，效率误差最大为1.82百分点；壁面粗糙度使得透平整体性能下降，对于本透平开机升功率过程中5个工况，在Ra1.6粗糙度等级下效率最大下降2.8百分点，且涡轮级粗糙度对透平性能影响更加明显；壁面粗糙程度越严重，涡轮级效率下降越大；在非设计工况，粗糙度达到Ra6.3等级时效率最大下降11.6百分点，壁面粗糙度加剧了动叶压力面的流动分离，造成了较大的摩擦损失，严重影响透平性能。研究成果为后续S-CO_2透平设计与性能研究提供了技术支撑和依据。

关键词(KeyWords)： 超临界二氧化碳;轴流透平;壁面粗糙度;试验测试

Abstract:

Keywords:

基金项目(Foundation): 国家重点研发计划项目（2018YFB1501004-4）~~

作者(Author): 王磊,霍文浩,唐国庆,但光局,孙冬婷,李扬,文俊

DOI: 10.19666/j.rlfd.202302019

参考文献(References)：

• [1] BONS J P. A review of surface roughness effects in gas turbine[J]. Journal of Turbomachinery, 2010, 132(2):021004.
• [2] BONS J P, TAYLOR R P, MCCLAIN S T, et al. The many faces of turbine surface roughness[J]. Journal of Turbomachinery, 2001, 123(4):739-748.
• [3]姚君,刘红.叶片表面粗糙度对透平叶栅气动性能影响的试验研究[J].燃气轮机技术, 2008, 21(2):28-31.YAO Jun, LIU Hong. The experimental research of effects of roughness on the turbine cascade loss coefficients[J].Gas Turbine Technology, 2008, 21(2):28-31.
• [4] LINDEN D H. Long term operating experience with corrosion control in industrial axial flow compressors[C].Proceedings of the Fortieth Turbomachinery Symposium,2011:93-106.
• [5]霍武军,孙护国.海航发动机压气机叶片腐蚀与防护措施[J].航空工程与维修, 2002(6):39-41.HUO Wujun, SUN Huguo. Corrosion and precaution for blades of aero-compressor in the navy air arm[J]. Aviation Maintenance&Engineering, 2002(6):39-41.
• [6] MARCO M, REINHARD N. Effect of surface roughness on loss behavior,aerodynamic loading and boundary layer development of a low-pressure gas turbine airfoil[C].Proceedings of ASME Turbo Expo 2010:Power for land,Sea, and Air. Glasgow:ASME, 2010:1535.
• [7] MOSHIZI S A, NAKHAEI M H, KERMANI M J.Development of a numerical based correlation for performance losses due to surface roughness in axial turbine[J]. Journal of Mechanics, 2014, 30(6):631-642.
• [8] ALQALADF J, TEIXEIRA J A. Blade roughness effects on compressor and engine performance—a CFD and thermodynamic study[J]. Aerospace, 2021(8):1-27.
• [9] LIPEJ A, MUHI?S, MITRU?EVSKI D. Wall roughness influence on the efficiency characteristics of centrifugal pump[J]. Journal of Mechanical engineering, 2017, 63(9):529-536.
• [10]李虹杨,郑赟.粗糙度对涡轮叶片流动转捩及传热特性的影响[J].北京航空航天大学学报, 2016, 42(10):2038-2047.LI Hongyang, ZHENG Yun. Influence of roughness on turbine blade flow transition and heat transfer characteristics[J]. Journal of Beijing University of Aeronautics and Astronautics, 2016, 42(10):2038-2047.
• [11]李勇,陈曦.粗糙度对汽轮机喷嘴内流动影响的研究[J].汽轮机技术, 2014, 56(5):321-324.LI Yong, CHEN Xi. Research about the influence of roughness on the flow inside the nozzles of steam turbine[J]. Turbine Technology, 2014, 56(5):321-324.
• [12]平艳,钟主海,江生科,等.表面粗糙度对透平叶片气动特性的影响研究[J].热力透平, 2021, 50(3):166-172.PING Yan, ZHONG Zhuhai, JIANG Shengke, et al.Analysis on influence of surface roughness on aerodynamic characteristics of turbine blades[J]. Thermal Turbine, 2021, 50(3):166-172.
• [13]何磊,黄启鹤,赵连会,等.重型燃气轮机透平叶片表面粗糙度对换热的影响[J].动力工程学报, 2019,39(9):711-716.HE Lei, HUANG Qihe, ZHAO Lianhui, et al. Influence of surface roughness of turbine blade on heat transfer in heavy-duty gas turbine[J]. Journal of Power Engineering,2019, 39(9):711-716.
• [14]余兴刚,谢诞梅,王纯,等.汽轮机叶片表面粗糙度对自发凝结级性能影响的数值研究[J].中国电机工程学报, 2015, 35(21):5533-5541.YU Xinggang, XIE Danmei, WANG Chun, et al.Numerical investigation of the effect of blade roughness on the performance of steam turbine nucleating Stage[J].Proceedings of the CSEE, 2015, 35(21):5533-5541.
• [15]蔡柳溪,高松,肖俊峰,等.壁面粗糙度对轴流压气机气动性能的影响[J].西安交通大学学报, 2017, 51(21):36-42.CAI Liuxi, GAO Son, XIAO Junfeng, et al. Effect of wall roughness on aerodynamic performance of axial compressors[J]. Journal of Xi’an JiaoTong University,2017, 51(21):36-42.
• [16]尚东然,刘艳明.粗糙度对多级压气机性能影响的数值模拟研究[J].推进技术, 2019, 40(12):2723-2730.SHANG Dongran, LIU Yanming. Numerical simulation of effects of roughness on performance of multistage compressor[J]. Journal of Propulsion Technology, 2019,40(12):2723-2730.
• [17]张骏,袁奇,吴聪,等.大型风力机叶片表面粗糙度效应数值研究[J].中国电机工程学报, 2014, 34(20):3384-3391.ZHANG Jun, YUAN Qi, WU Cong, et al. Numerical simulation on the effect of surface roughness for large wind turbine blades[J]. Proceedings of the CSEE, 2014,34(20):3384-3391.
• [18]徐维晖,侯晓,胡孟,等.粗糙度对离心泵空化过程的影响[J].排灌机械工程学报, 2018, 36(3):197-203.XU Weihui, HOU Xiao, HU Meng, et al. Impact of wall roughness on cavitating process in centrifugal pumps[J].Journal of Drainage And Irrigation Machinery Engineering(JDIME), 2018, 36(3):197-203.
• [19]史磊,刘嘉琦,黄晨雷.表面粗糙度对离心压气机气动性能影响分析[J].航空发动机, 2022, 48(3):13-19.SHI Lei, LIU Jiaqi, HUANG Chenlei. Influence analysis of surface roughness on aerodynamic performance of centrifugal compressor[J]. Aeroengine, 2022, 48(3):13-19.
• [20]唐凯,刘志刚,王晖,等.叶片表面粗糙度对前弯压气机叶片流动特性影响的试验研究[J].推进技术, 2020,41(8):1710-1719.TANG Kai, LIU Zhigang, WANG Hui, et al. Experimental investigation of surface roughness on flow around forward-skewed compressor blade[J]. Journal of Propulsion Technology, 2020, 41(8):1710-1719.